Oliver International outflow mechanism replaced Diamante
Step 1 <1999
In this example, we explain how to replace an Oliver International Diamante outflow mechanism. This type was available until December 1999 and a later version after that, which also became a dual flush. We'll cover both reservoirs here.
Step 2 <1999
Now the mechanism is loose and you can remove it from the valve holder. Simply pull it out. You won't be using it again.
Step 3 <1999
To make the mechanism suitable for single flushing, we attach the included hook to the included pipe. We remove the upper part of the supplied mechanism using the dual-flush technique (which is not used for the older model). The hook and pipe are used in its place.
Step 4 <1999
Depending on the toilet bowl (older models often need 9 liters to flush properly), you can adjust the number of liters and install the new mechanism.
Step 1 >1999
First, loosen the bridge piece by pushing a clip back and releasing it to the left and remove it from the frame.
Step 2 > 1999
Now release the downholder by moving it to the left and remove it from the frame.
Step 3 > 1999
Now the mechanism is loose and you can remove it from the valve holder. Simply pull it out. You won't be using it again.
Step 4 > 1999
The new mechanism comes with the dual flush technology, which you also use. You don't use the hook and the pipe.
Step 5 > 1999
Depending on the toilet bowl (older models often need 9 liters to flush properly), you can adjust the number of liters and install the new mechanism.
